NEW

Exciting new tools are live – check them out now! Learn More

Putting a Small Boat Away for Winter

Putting a Small Boat Away for Winter

For boaters in cold climates, fall means hauling out and putting the boat to bed. A careful winter layup prevents the most common springtime problems: cracked engine blocks, mildewed cushions, dead batteries, and soggy wood. Here’s a checklist for a typical small powerboat or sailboat. Always defer to your engine manufacturer’s manual where it differs.

Engine and fuel

  • Stabilize the fuel. Add fuel stabilizer, then run the engine long enough to get treated fuel through the system. Many owners fill the tank to limit condensation; follow your manufacturer’s advice for your fuel system.
  • Change the oil on four-stroke engines before storage, so acidic used oil doesn’t sit in the engine all winter.
  • Drain or protect cooling water. Water left in an engine block or manifold can freeze and crack it. Outboards usually drain when tilted down, but inboards and sterndrives need to be drained or filled with non-toxic antifreeze made for marine engines.
  • Fog the engine if the manual calls for it, to coat the internals against corrosion.
  • Grease fittings and check the lower unit oil. Milky gear oil means water is getting in, and that seal should be fixed before spring.

Plumbing

Any system that holds water needs attention: freshwater tanks and lines, water heaters, heads, and raw-water washdown pumps. Drain them and run approved non-toxic antifreeze through the lines. Don’t use automotive antifreeze in a potable system.

Electrical

Charge batteries fully, then remove them for storage or connect a maintainer. A fully charged battery is far less likely to freeze than a discharged one. Clean corrosion off terminals while you’re at it.

Hull, deck and interior

  • Wash the hull and check for blisters, cracks or damage while it’s easy to see.
  • Take home cushions, life jackets, electronics and anything that can mildew or walk off.
  • Prop lockers and hatches open slightly for airflow, and consider moisture absorbers in closed spaces.
  • On wooden boats, keep rainwater and snowmelt out. Freshwater sitting in a wooden boat is a recipe for rot.

Covering

A cover should keep weather out while letting air move. Shrink-wrap is popular for its snug fit but needs vents to prevent condensation. Tarps over a frame work well if they’re tied down so they don’t chafe the hull in the wind. Make sure the cover sheds snow. Pooled water and snow can be very heavy.

Write it down

Keep a list of anything you noticed that needs fixing. The off-season is the time to order parts and book work, before every yard is slammed in April.

Leave a Comment